where do i place curtain holdbacks

Best answer


Look at the window treatment that covers your windows. …Make a pencil mark on one side of the window where you want to set the curtain holder. …Measure the location of the curtain holdback from the bottom of the floor on the side you marked and repeat on its opposite side and make a mark.Hold the curtain hook drawback or medallion post bracket level at the penciled location,and make a mark through the holes for the screws with the pencil.Make a small pilot hole with the drill and drill bit sized to the fastener if you are installing screws.Drill a hole sized to the toggle bolt with a drill bit if you are installing in drywall without a stud behind it.Insert the toggle bolt wings by holding them while they’re collapsed through the hole until they open inside the wall.Place a level on the hook-shaped curtain holdbacks and readjust as necessary to ensure they are level.

People also ask


  • How do you install a curtain holdback?

  • How to Install Curtain Holdbacks 1 Look at the window treatment that covers your windows. … 2 Make a pencil mark on one side of the window where you want to set the curtain holder. … 3 Measure the location of the curtain holdback from the bottom of the floor on the side you marked and repeat on its opposite side and make a mark. More items…

  • How high should a curtain hook be off the floor?

  • Most curtain holdbacks are installed between 40 to 48 inches up from the floor, but it is a personal choice where you install them. Hold the curtain hook drawback or medallion post bracket level at the penciled location, and make a mark through the holes for the screws with the pencil.

  • How high up should tiebacks be on curtains?

  • If you are using long rope tassels as tiebacks on floor-length curtains, attach them 5 to 6 inches higher up the wall than you would attach standard tiebacks. If the plumb line falls within 1 inch of the inside edge of the window frame, attach the tiebacks slightly farther out.

  • How do you attach a tieback to a window?

  • When the string touches the curtain, pull the curtain panel in toward the the middle of the window so the string hangs freely. When the weight settles, place a ruler at the mark you made for your desired level, and make a second mark where the ruler meets the plumb line. This is where you should attach the tieback.

    where do i place curtain holdbacks

    Leave a Reply

    Your email address will not be published.

    Scroll to top