how to set curtain rod

Best answer


Slip all the curtain rings onto the rod and place the rod on the holders. Then screw in the stop end for the right end of the rod. Finally, screw some small screws through the holders into the rod to stop the rod from slipping sideways.

People also ask


  • How do you install curtain rods?

  • Before you install curtain rods, decide where you want the bottom of your curtains to fall, and use a measuring tape to determine where the top of the curtains will be. Mark this spot on either side of your casing and use a laser level to make sure your marks are even. Next, mark the locations where the bracket screws will go.

  • How do you hang drapes from a round rod?

  • To hang, you must place drapery pins in the pleat, and then hang them on the rod. A cord allows you to pull the drapes open and closed. Panel curtains, eyelet curtains and tab top curtains are meant to hang from a plain round rod. They may have a pocket along the top to push the rod through,…

  • How do you increase the length of an expanded curtain rod?

  • Consider the length of the rod when hanging the brackets. Though most curtain rods are adjustable, you don’t want the distance between the brackets to be so wide that the rod sags in the middle. In general, you shouldn’t increase the length of the expanded rod by more than 50 percent. Drill pilot holes to help start the screws.

  • How do you measure for a wall mounted curtain rod?

  • Wall-mounted rods are usually installed four inches above the window. To find your ideal placement, measure down from the ceiling to the top of the trim at the left corner of your window; mark the midway point. Repeat this in the middle of your window frame and in the right corner, then check your markings with a level.

    how to set curtain rod

    Leave a Reply

    Your email address will not be published. Required fields are marked *

    Scroll to top