how to mount a curved shower curtain rod

Best answer

Review the Curved Shower Rod Mounting Instructions above to determine proper rod placement.Assemble curved shower rod. Hand-tighten remaining screws. Do not use set screws at this time.Have someone help you measure. Hold rod up to desired position,one person at each end,to check height and location.Remove the retaining screws. Separate the wall brackets from the rod. Leave the swivel connectors on the rod.Place the brackets back on the wall at the pencil marks.Mark screw holes at 12 and 6 o’clock positions. Set wall brackets aside.Using a 1/4 drill bit,drill screw hole as marked. Make sure hole is clear of dust. Tap anchor into hole until flush with surface.

People also ask

  • How do you mount a shower curtain rod to a wall?

  • The shower curtain rod does not mount to these walls in most cases. It mounts to the bathroom wall, about 1 inch above this sidewall. The mounting brackets screw into place in the bathroom wall’s drywall. If you drill into the tub sidewalls, which are made of fiberglass, you ruin the watertight nature of the tub walls.

  • How high should you hang curved shower rods?

  • To prevent the curtain from dragging on the floor of the tub, hang the curved shower rod at a height of 74 inches or more. If your bathroom ceiling is so low that you will be unable to install the curved shower rod at the appropriate height, modify your shower curtains so that they are short enough that they won bunch up on the bottom of the tub.

  • How high should a shower curtain be above the tub?

  • At the opposite end, ensure your rod is not so high that the bottom of the shower curtain is above the edge of the tub. Place the shower rod at least 74 inches (188 cm) above the shower floor. The standard shower curtain is 72 inches (183 cm) long, and when it is linked to shower hooks, it usually gains another two inches (five cm).

  • Why do you put a curved shower rod inside a tub?

  • That’s to prevent unnecessary splashes of water outside the tub. If you’re installing a curved shower rod along a standard 60-inch tub, then mount the rod about 3 inches inside where you’d install a straight rod. The midpoint will extend several inches outside the tub.

    how to mount a curved shower curtain rod

    Leave a Reply

    Your email address will not be published. Required fields are marked *

    Scroll to top