how to get curtains to pleat

Best answer


Theheading tapeis the top section of the curtain that contains 3 cords,which are used to scrunch the curtains into pleats. Gather the 3 cords at one end of the heading tape. Tie a knot by looping the cords and pulling the loose ends through the loop. Pull tightly to secure the knot.

People also ask


  • How do you sew pleats to a curtain?

  • Open the pleat channel, a wooden spoon inserted into the top works well. Grasp the finger-pressed fold and pinch an inch. Push this pinched section down against the curtain, aligning to the seam. The remainder of the pleat will fan out on either side of this center pinch.

  • How to hang pinch Pleat curtains?

  • To hang pinch pleat curtains, you need pins to make the pleats with accurate measurements. Putting the curtains on the rings is the most tedious step. Anchors, rods, and rings are used to hang the curtains as the rod fits over or through the anchor with a 12-step process.

  • How do you fix pleated curtains with no pockets?

  • If your curtains do not have a pocket, then tuck the cords underneath one of the pleat strings. Using a slip knot will make untying the knot easier when you take the curtains down to clean them. Even out the pleats once the curtain is secured.

  • How many pins do I need for a pleated curtain?

  • Count the number of pleats that you have. You檒l need one hook for each pleat, plus a beginning and endpin. If you have an eight-pleated curtain, you檒l need ten pins. In addition, lay out the number of rings or gliders you need.

    how to get curtains to pleat

    Leave a Reply

    Your email address will not be published. Required fields are marked *

    Scroll to top